I was gifted an awesome A1 size pen plotter and needed a spot to easily create some artwork. Might as well also store some supplies and have a place to sit at right? I came up with this design that is rather specific to its ultimate resting place; sandwiched between my wife’s desk and mine.

I cut some mortise and tenons for the legs with the help of a table saw and router.

Used just about all of the clamps I had and a soft hammer to help square it up.

Adding the front facing dividers that will help support the boxes / drawers.

For the drawers, I went with a joint that hid the outside connection, as described in this video by James Hamilton. I was trying to use the wood I already had, which resulted in the drawers being made of wood with different thicknesses. So I had to adjust the saw more frequently. Wish I took more work in progress pictures of the boxes 🙁

Added all of the rails for boxes to slide on. The wide opening at the top is for paper to slide into.

The rails are solid pieces of wood for strength. I did some rabbets and dados and grooves and what nots.

All of the drawers pull out for transporting of supplies, pens, brushes, paints, etc.

Final resting place between our two desks. It has wheels so we can roll it out if needed. The metal top is great for using magnets to hold the paper.

My daughters needed stools to brush their teeth. We had trouble finding one that was wide enough for the both of them. My generous neighbor gave me a thick piece of mahogany(?) and I thought it would be perfect for the piece.

The piece was too thick to cut through completely with the table saw. I finished the cut by hand with a pull saw.

Took a while to halve the slab. I couldn’t seem to get all of the dominos out of the board.

I joined the two pieces with some wood glue and a half lap joint to make one longer board for the top.

I cut some of the dovetails on the band saw. And the angled ones by hand.

I made some dados(?) to hold some runners under the top plank.

Glue up after the top dove tails are complete.

Wood pegs were used to help with strength to join the smaller step.

A generous neighbor who’s a carpenter gave me some smaller pieces of ipe wood. It was very dense and more difficult to work with than what I am used to. It is very durable and weather resistant; between that and the size of the board, I immediately thought of a penny board.

Trying to make a slight concave on the deck to help with grip. I tried running the board perpendicular along the blade using the white board as a guide. I raised the blade up slowly per pass. It wasn’t as effective as I had hoped on a board of this size.

The belt sander helped smooth things out a bit.

I printed out a guide for cutting and used the band saw to get it close to the edge.

I clamped the belt sander down to use it to get close to the edge.

I drew a pattern on the top with a marker and then dug into it with the Dremel tool.

I bought some Paris trucks for itty bitty boards and some cruising Super Juice wheels. It’s just under 6 inches wide; my toes and heels hang off the edge.

There weren’t very many dovetails, but the long flat stretches between them proved difficult to cut using a band saw.

I used a plexiglass circle template with a router bit and bearing to make the initial circle. But the depth was too shallow and I didn’t want to use an extension. I purchased some little sphere rotary burrs, rough and smooth for the drill and finished the rest by hand. I cut the exterior wood with a band saw and did a ton of sanding. I finished them with the natural finish Tried and True.